Hi all, just joined your group after reading some of your postings. There was some talk about wiring off pots and I thought I could share a tip with you by way of introduction: If, as I do, you slide your pots onto a selection of small wooden boards it can create a'sticky' problem when you later come to remove the pot to 'turn/trim' it, most people run a wire under the pot for a second time.I have found that if you wet a sheet of newspaper (torn to fit the board), lay it over the board (keeping it fairly smooth)and slide the wired pot onto it, when you come to trim it later it will lift off the board easily;sometimes a circle of paper stays on the base of the pot but this is no problem to peel off.
- posted
18 years ago