Coverlock stress

Have a question or want to show off your project? Post it! No Registration Necessary.  Now with pictures!

Threaded View
Yesterday's adventure.
Janome 1000 CPX was working perfectly but I was about to start a new  
project so I decided to change the needles. The result of this move was  
skipping all over the shop. Various tweaks had little result. 1 pot of  
tea later it occurred to me that most of the skipping was on the RH  
needle so I took it out and put it back in again and went from pure  
frustration to happiness in one moment.
The lesson is; It's not enough to have the right needles, in this case  
suk, make sure you have them properly inserted/seated.
Claire in Montreal FRANCE

Re: Coverlock stress
Claire in France wrote:
Quoted text here. Click to load it

Been there, done that.  :-O

Site Timeline