1. Home
  2. Sewing Discussions
  3. problem with special stitch dial on Singer 401A
  4. Page 2

problem with special stitch dial on Singer 401A

Thanks! I'll take a look there, too. Does the round opening on the front of the case just to the left of the control not reach that spot?

Beverly

Reply to
BEI Design
Loading thread data ...

I remember back in 1975, when I bought my White sewing machine which is still going strong, the saleswoman told me "Everywhere you see metal against metal, you put a drop of oil." That has served me well as a general rule of thumb. The Janome I bought about seven years or so ago, however, came with the instruction "Do NOT oil this machine."

Olwyn Mary in New Orleans.

Reply to
Olwyn Mary

NO that is the for gear shaft, there is an upper and lower hole for those You can get in through the opening where the lever is if you have a long spout or from the top

Reply to
Ron Anderson

Very good rule of thumb.

Reply to
Ron Anderson

Thanks! I bought one of those oil dispensers with the long, flexible, extendable spouts, so I can reach just about

*anywhere*. I'll give it a shot.

Beverly

Reply to
BEI Design

InspirePoint website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.