I got the lathe last night and love it, but want to go 220v..
The manual says that it will run on 110 or 220 and implies that it eats whatever you plug it into.. I'm thinking that there should be some wiring or jumper change involved first?
The closest info I could find was on the 3000 dvr, showing them pull the back of the headstock off and removing a jumper.. There is NO mention of this in the xp manual...
I've always had to change the wires in the starting capacitor before, but this motor doesn't seem to have one??
Any help appreciated..
mac
Please remove splinters before emailing