Rings and excess CA

Have a question or want to show off your project? Post it! No Registration Necessary.  Now with pictures!

Threaded View
I made these rings yesterday.  I have excess CA glue on the core but I was afraid to use CA removal fluid to remove the CA.  I thought the removal liquid is so flowing that it might compromise the CA holding the wood to the core.  What do you think?  

From the left or bottom is poplar wood (with CA finish), middle is lignum vitae (no finish) and top or right is bloodwood (CA finish).  


https://www.dropbox.com/s/n0gkkj06xhk8ece/Rings%20bloodwood%20lignum%20vitae%20poplar1.JPG?dl=0

https://www.dropbox.com/s/a3z5so20ounamkj/Rings%20bloodwood%20lignum%20vitae%20poplar.JPG?dl=0

Re: Rings and excess CA
Quoted text here. Click to load it

Very nice.  
  I would try the removal fluid applied with a paper towel so as to not
flood the joint area.  

Re: Rings and excess CA
On Tuesday, December 12, 2017 at 12:32:08 AM UTC-5, Leon wrote:
Quoted text here. Click to load it

Thanks for the suggestion.  A contact suggest using jewelers rouge with a dremmel pad bit.  

Site Timeline