Hello I was wondering if there is some one with a Vicmarc VL300 lathe who could get some measurements for me. I'm unable to get access to my machine, cause I'm working away from home, and what to make a 3 point steady and need to know the measurements from the bed to the center of the head stock. It would be nice to have these in metric but thats not critical. Regards Peter
Measurements from Vicmarc VL300
Jun 06, 2004
1 Replies
Peter, The bed to headstock should be 12 inches (24 inch swing), in millimeters (12 X 25= 300mm). The gap between the ways is 2 1/2 inches if I remember right. I can check when I get home. Take it easy, Guy
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required