Woodturning Crafts

  1. Home
  2. Woodturning Crafts
7010 Threads Posts
to

Worth reading in Woodturning Crafts

Odds & Ends

Ralph, This guy might be a source for faceplates or even an adapter that would go from your 3/4" x 10 to 1" x 8. http:/...
0 comments posted 19yrs
posted by harrypye
0 comments posted 19yrs posted by harrypye

Adaptor

I have a Shopsmith and have used it for about 15 to turn wooden bowls up to about 11" in diameter (both natural wood an...
1 comments posted 19yrs
posted by bldaun
1 comments posted 19yrs posted by bldaun

dupilcator ?

I have a stairway and railing around the upper opening which is going to require about 92 oak (balusters) spindles. The...
5 comments posted 19yrs
posted by houchen
5 comments posted 19yrs posted by houchen

Rikon 20" lathe

I was checking out the Rikon power tools website and saw that they added a new lathe. Here's the link: http://www.rikont...
3 comments posted 19yrs
posted by taunt
3 comments posted 19yrs posted by taunt

Reeves drive lubrication

There was a thread here lately on the Sears 15" Reeves drive lathe. I lost the thread, but I had the lathe jam on me to...
6 comments posted 19yrs
posted by darrellfeltmate
6 comments posted 19yrs posted by darrellfeltmate

Wood turning on You Tube

I am sure there are a lot of you that have discovered you tube but for those of you that have not, there are several go...
0 comments posted 19yrs
posted by LBledsoe
0 comments posted 19yrs posted by LBledsoe

Comments on Comments

Last year this time I started on a slippery slope making some tree ornaments on the used Jet lathe I picked up on a goo...
9 comments posted 19yrs
posted by aLurker
9 comments posted 19yrs posted by aLurker

Peppermill advice requested....

I got some stuff to turn a peppermill as a present, along with some wood. Which is all fine. Well except for a spring m...
4 comments posted 19yrs
posted by dgsdfgsdgsd
4 comments posted 19yrs posted by dgsdfgsdgsd

Ne "Work in Progress"

Hello friends. There have been a couple of additions to Around the Woods. There are some simple changes to the sharpeni...
0 comments posted 19yrs
posted by darrellfeltmate
0 comments posted 19yrs posted by darrellfeltmate

This is getting bad

I've only had my lathe for a couple of weeks and I can't believe how slippery this slope is. Let me give you a couple o...
6 comments posted 19yrs
posted by ddurbin
6 comments posted 19yrs posted by ddurbin

Merry Christmas and Happy New Year

It has been a quiet but good Christmas Day after a wonderful Candle Light service for Christmas Eve. One daughter was h...
2 comments posted 19yrs
posted by darrellfeltmate
2 comments posted 19yrs posted by darrellfeltmate

What moisture meter

What is best for testing moisture content of wood, a two pin or a four pin tester? Andy.
14 comments posted 19yrs
posted by handy-andy
14 comments posted 19yrs posted by handy-andy