Woodturning Crafts

  1. Home
  2. Woodturning Crafts
7010 Threads Posts
to

Worth reading in Woodturning Crafts

Third Bite of Beech

Just watched "Love at First Bite" last night again, so those familiar will recognize the significance. As you can see,...
3 comments posted 20yrs
posted by George
3 comments posted 20yrs posted by George

lathe chuck

I have just seen an ad for the Penn state inds. chuck . Does anyone have info on these chucks. they are about half price...
22 comments posted 20yrs
posted by gdd
22 comments posted 20yrs posted by gdd

Just a thought

Just a thought. Say you have an unlimited supply of logs (I wish) and were not bothered about wastage. What would be th...
6 comments posted 20yrs
posted by thomasdougall
6 comments posted 20yrs posted by thomasdougall

It's good to be back!

Hello everyone, Most of you...in fact I would guess none of you remember me, but I used to come here all the time. I us...
10 comments posted 20yrs
posted by thorndike
10 comments posted 20yrs posted by thorndike

Crazy (and lucky) or Common?

Crazy (and lucky) or Common? Made a 1/16th, minus a little, inch wide parting tool from a used seven or eight inch long...
14 comments posted 20yrs
posted by charlieb
14 comments posted 20yrs posted by charlieb

THE INTERNATIONAL WOODWORKING EXHIBITION 2006

I am pleased to confirm the '#1 woodworking show' is on! Over the last couple of months Highbury House Communications h...
0 comments posted 20yrs
posted by ben.wright
0 comments posted 20yrs posted by ben.wright

Big Lathe?

Hello to all, I have a small Ryobi lathe. My father bought it, never used, and I ended up with it. You all know this pa...
38 comments posted 20yrs
posted by dweeks
38 comments posted 20yrs posted by dweeks

Segmented Pot

No, it's not a new type of Cannabis sativa... It's my latest project - A Segmented Pot of Soft Maple and Walnut. My 9th...
5 comments posted 20yrs
posted by GregG
5 comments posted 20yrs posted by GregG

Veneer

Hi guys, I am looking for a good economical source of wood veneers in Canada, to be used in segmented turnings. Anyone h...
0 comments posted 20yrs
posted by wslaney
0 comments posted 20yrs posted by wslaney

Apprentice Chuck System Q&A

I am relative newbie and have been monitoring the group for a couple of months. I have a Jet JWL-1236 lathe and at the...
2 comments posted 20yrs
posted by massmans
2 comments posted 20yrs posted by massmans

I have a date!

Greetings all No, not that kind of a date! We have finally solidified a date for filming the next video. Once again I w...
6 comments posted 20yrs
posted by bill
6 comments posted 20yrs posted by bill

Top Grind Pepper Mill Mechanisms

I've been searching for a top mounted pepper mill mechanism. (Bottom load, top grind, spills no pepper on the table.) S...
10 comments posted 20yrs
posted by GregG
10 comments posted 20yrs posted by GregG

Firewood is Good - Beech

Grabbed a couple hours of turning yesterday afternoon. Devoted a section of beech branch that still had bark to protect...
1 comments posted 20yrs
posted by George
1 comments posted 20yrs posted by George