1. Home
  2. Machine Embroidery
  3. Barudan Beat IV - PC Connection

Barudan Beat IV - PC Connection

Hi everyone! I hope someone on this forum can help me out I have and older single head Barudan Beat IV embroidery machine which has an FDR-V Floppy Reader. Does anyone know if I can purchase a cable and/or hardware that can connect my PC straight to my Barudan machine. Could you tell me where I could purchase this from and how much it will cost me. Also instructions on how to connect would be very useful. I would like to eliminate the use of floppies in the FDR reader. At present I am running Windows XP on my PC. Looking forward to any replies that may help me. Rockey.

Reply to
rockey
Loading thread data ...

Contact 'Wilcom' in your local area. They provide a hardware/software solution to connect your old machine. You'll either need a 'DCi' or a 'Parallel Connect Cable' to connect the embroidery machine directly to a PC. And compatable software to upload designs, eg: ES-Designer.

Contact Wilcom:

formatting link
connection info:
formatting link
my old 'Barudan' 1986 (Honda Connector) model connected with DCi Serial/Parallel to Wilcom - ES Designer.Used to upload designs using a 'paper tape' reader.

-D

Reply to
Digitizer

cindymccain had written this in response to

formatting link
:hi Rockey

i just bought this mach> Hi everyone!

-------------------------------------

*** *** ***....** **...*** **........** **.......** *** **..........*.........** *** **.....** **..................** **.....**

##-----------------------------------------------## Delivered via

formatting link
Community of the NetWeb and RSS access to your favorite newsgroup - alt.sewing.mach-embroider - 1980 messages and counting!##-----------------------------------------------##

Reply to
cindymccain

InspirePoint website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.