I bought a used Brother 1210 AC embroidery machine. It embroiders well and cuts the color changes and end of the design thread but does not cut the jump stitches/trims.
I have read the Instruction Manual many times but have found no place that explains how to get the trimmer to cut jump/trim commands. The Operation Panel thread sensor setting shows "trimmer is ON." All of the dip switches on the Operation Panel Box are set to the OFF positiion. The dip switches on the Circuit Board Box are as follows: switches 4, 7, and 8 are in the ON position switches 1,2,3,5, and 6 are in the OFF position
Would someone please help? I am hoping someone in this group knows the answer to my problem.
Thanks