controller

Hello, I recently aquired a kiln, but there are some issues. The biggest issue is that it runs on 220v and i do not have a 220v outlet in the garage i plan on using it in. I was wondering are the heating elements in it specific to 220v or if i was to replace the controller with a

120v controller would it still work. (I know enough about electricity to do that safely otherwise i would not even attempt it.) thank, jeff
Reply to
J
Loading thread data ...

It might still work, but your biggest problem will be that it'll take forever to heat up. The elements have a fixed resistance, so by Ohm's Law, if you cut the voltage in half, you'll cut the current (in Amps) flowing through the elements in half. That'll cut the power (in Watts) by a factor of four. If the kiln was rated for more than about 30A at

220V, you'll have another problem: it'll want to draw more than the 15A your outlets are probably rated for, you'll blow a breaker, and it won't heat up at all.

In addition to that, kiln designers carefully calculate all sorts of factors like power per square foot, power per cubic foot, power per square inch of element wire, and so on that will be thrown way out of whack if you give it 1/4 of the power it's expecting, so even if it does heat up in a reasonable amount of time, it's likely to give you poor performance.

All in all, it's probably worth it to get a 220V outlet hooked up if you want to use that kiln. If you want to use 120V, sell that one and use the money to buy a little 120V kiln. (And it will be little, because 120 volts at 15 amps just isn't that much power, really.)

Reply to
Ron Parker

Sounds like your intentions are good but your thinking is off a bit.

The controller is probably already 110, and running off one leg of the power coming in for the elements, you don't mention the maker of the kiln, and it really is not all that important, but to put a service box in and a 220 outlet off that is not an expensive endeavor, and it is a one time cost. Remember, even for the rest of the home, the kiln is not something that is drawing power all the time, only intermittent use.

Reply to
javahut

InspirePoint website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.