Wooden Frame for Panel

I'd say glue and one staple are not enough, glass is very heavy and gravity is not your friend.

This reminds me of a recent accident at a glass show I participated in. Someone had a stained glass panel in a wood frame. I believe they used eye hooks in the top side of the frame which split the wood (anyway, the wood frame split somehow). Unfortunately, underneath the hanging panel was a glass sculpture and an art glass table. All 3 were damaged and the show sponsor representative was looking them over during the opening reception. I don't know if all three artists were reimbursed, but I bet they were pretty unhappy about the damage.

Once, I had to call an artist at the beginning of a show set up and say "you used the wrong type of glue, you piece is falling apart, get over here".

So it just makes sense to make your art as secure and tough as possible.

Good Luck,

If the panel were glued into the frame with silicone the frame would be strong enough. the panel would hold the frame together. If the panel is not glued to the frame the frame may not be strong enough. Carpenter's glue is very strong when the pieces to be glued have grains that are within 45 degrees of being parallel. Carpenter's glue won't last when end grained glued as in a mitered corner. What you've got is a frame that may eventually be held together only by the staples. If you had used a frame vise and brads or finish nails on the corners they might have been strong enough. You could do that now and I think it would be strong enough. I am a carpenter.

John Bassett

Hi John, Since your a carpenter maybe you can answer this question for me. What is the name of the wavy pieces of metal that are hammered into to the mitered edges? I guess they are used instead of staples. Are they any good or do they weaken the wood and cause splitting later? Thanks

I was just looking at an 12x17 oak frame I have for SG but have not used yet. It does not have any hanging apparatus. Any advice on what to use and the best placement for it. TIA

I've used these before...they seem to work OK.

There seems to be a problem with the link, care to give a description? Is

I don't know why the link didn't work....the item # is 8841. Enter this number in the search window at Delphi's site.