9 discussions on InspirePoint about the Jet JML-1014: what owners asked, what went wrong, and what fixed it.
I have a Jet mini lathe, model number JML-1014.I lost the retaining clip that prevents the handle of the tailstock from sliding out of the assembly (part number JML-63 - C-Ring)I went to but they don't have my lathe listed in their parts...
All: I need some measurements from various lathes -- if you could report: Make and model of your lathe Spindle size and thread pitch (i.e. 1 1/4 x 8) Dimensions 1 and 2 from the photo -- it would be most helpful. The photo is of a much...
Good morning, I'm interested in these jaws: But I have a couple of questions. I have a Jet JML-1014 lathe with a 10" s wing. I'm wondering if these will fit. The largest bowl I can turn is ~ 1 0" and I hate to give up too much of that...
Hello,I am new to turning. I got a Jet Mini Lathe (JML-1014) for my birthdayalong with the bed extension. I purchased a few tools from Lee Valleyand am very gung ho to start turning and learning. However, its damncold out in the garage...
Since I can't get a Jet mini lathe in Canada I have to go down to Seattle to the Woodcraft store to pick one up. If anyone owns one of these, could you check if it is CSA approved? It would have a small "c" on the left side of the UL...
Hi!Does a Jet JML-1014 Mini Wood Lathe have to be bolted down? Supposedlyweighs 72 lbs.I will be using it mainly for 10" or less bowls, vases, boxes, etc...I was planning on putting it inside a Spray Booth I built a while ago buthardly use...