I am putting the elements in a skutt 1027. I have the elements in an now am putting the connectors to the box. I clamped the connectors to the box wires and before I took them off I numbered the wires 1, 2, 3, and 4.
1 going to the top element, 2 going to the same element but down one. I got three and four on according to the sequence, but then put 1 where I should have put 2. It goes to the same element. Will it make a difference with the switch if I leave it as is or am I going to have to cut the connector off and put it on as numbered?I really did not want to have to cut the connector off unless I absolutely have to. I know, I know pay attention right................
Randy