Re: Satin Stitches on Lycra fabric

Sep 12, 2005 2 Replies


Hi!


>There are two methods that I have found work quite well: for velvet lycra
>glue (I have used Aleene's stretchable flexible fabric glue with good
>results) a stabiliser in place on the right side of the fabric that is
>slightly smaller than the finished design. Leave to dry. When dry, go
>ahead with your stitching.
>Method number two is to paint the general area of stitching with a heavy
>starch. Again, leave to dry. When dry, go ahead and do the stitching.
>Wash out the starching when the project is complete.
>Good luck!
>Cynthia

Hi Cynthia, That is an amazing idea you have there. If I understand you correctly, you put your design on with the glue-based "stretchable-flexible" product....then after it is dry....you are basically freehand zig-zagging over the raised surface? Never would have thought of that. Nice results? What a great idea. Thanks, Joy

Awesome results, Joy:

I used this method (after much trial and error on scraps!) to do the design on my daughter's Irish dress. I used velvet lycra instead of regular velvet because the fit and look is nicer. The greatest complement on the dress was when a troupe of Irish dancers came to town and performed at the elementary school. Jenn also performed her dance (it was multicultural week) - and those dancers wanted to take a closer look at her dress! I did the freehand zig-zag using a rayon embroidery thread and a tear-away stabiliser on the back of the fabric (I used the kind that is sort of lightly 'waxed' paper - not the fabric. Because you are working with a stretch fabric, applying any kind of heat is a no-no, but that goes on with a slightly warm iron.) For Irish designs on regular lycra, I usually paint them on with flexible paint and a very fine brush or use a bottle with a fine hole. I have done several group costumes over the years and all of the outfits are still in use. Cynthia

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required