Cylinder vase

i've seen things like that in places like michaels or cost plus. they were pretty expensive though.
Reply to
charlie
12 in dia is pretty large, but did you happen to call Blenko? I just got a line on one from them that was 7 in diameter, but 14 in tall.
Reply to
Javahut
On Mon, 14 Jul 2008 22:35:38 -0400, "Javahut" wrote:
Thanks to all who responded. I've checked all over the web.
This is for a lighting company that I do bending for. They were hoping I could do it in a kiln. The guy that was going to blow it backed down. I'll keep searching.
Jack
Reply to
nJb
nJb wrote in news: snipped-for-privacy@4ax.com:
Have you tried TJMaxx or BigLots, or other overstock/surplus outlets in your area?
Reply to
Kris Krieger
nJb wrote in news: snipped-for-privacy@4ax.com:
I think the main problem with kiln-forming would be the height - I don't know whether kilns are that deep. Other than the interior height of the kild, Idon't see whay it couldn't be done, but I'm certainly no expert! But you can try asking this glass-artist:
formatting link

Reply to
Kris Krieger

InspirePoint website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.