Deck box from one piece of thick leather

Nov 18, 2026 Last reply: 3 hours ago 3 Replies
Jump to replies (3)

The detail that surprised me most here is that the whole box starts as a single piece of leather, roughly 7 oz, folded and stitched into shape rather than cut into panels and joined. Joshua Arens built this as a storage box for trading card games, and the maker says it suits Magic: The Gathering, Pokemon, Yu-Gi-Oh, or just an ordinary deck of cards.



The construction sequence reads like a textbook exercise in doing things in the right order. Fold lines are scored into the cut pattern with a groove gouge run along a metal ruler over a green self-healing mat. Relief holes get punched at the inner corners with a round drive punch and a mallet, which seems like a sensible way to keep those corners from bunching up. Edges are beveled and burnished with gum and a cloth before any stitching holes exist, then multi-prong pricking irons are hammered in for straight seams, and a handheld awl is pressed through at a 45-degree angle along specific edges to prepare the stitching holes. At the corners the awl goes in two directions, getting things ready for box stitching.



The box is saddle stitched entirely by hand with needles and thread, assembling the side seams and the lid closure flaps. A two-piece magnetic rivet snap closes the front panel against the flap. The finished piece is tan, embossed with a circular letter M logo, and shown holding a sleeved deck.



Two things are still open. The maker says a sewing pattern exists, and that the design can be customized with things like a belt loop or engraving, but how many cards the pattern actually fits has not been stated, and neither has how the logo was applied. For anyone playing commander with a fully double sleeved hundred card deck, capacity is the first question I would want answered.



Project by Joshua Arens. Watch it on their YouTube channel:

formatting link


Punching relief holes at the inner corners before stitching is the choice that stands out to me. Corners are where folded leather fights you the most, and giving them a relief hole up front should make the folds sit cleaner and take stress off the seams. The trade-off is that you have to commit to those hole positions before you can test the fold, so placement has to be right the first time.

I would love to know how the circular M logo was put onto the leather. Embossing a crisp circle with a letter inside looks like it takes either a custom stamp or a lot of careful hand work, and getting it centered on the flap of a folded single-piece design can't be easy. Has the maker said anywhere what was used for it?

Since the maker says the design can be customized with a belt loop or engraving, a version with a belt loop would be my first variation. It would turn the box into something you can carry to a game night without needing a bag, and on 7 oz leather the loop could be saddle stitched on with the same pricking irons and awl work already used for the rest of the build.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required