Leather snow goggles from a historic Inuit design

Nov 18, 2026 Last reply: 3 hours ago 2 Replies
Jump to replies (2)

Bright glare is the problem this build takes on. Nils Beardfoot made a pair of leather eyewear based on traditional snow goggles from Inuit culture, where narrow horizontal slits cut the light reaching the eyes while still letting the wearer see where they are going. Turning that idea into a wearable piece of leatherwork is a lovely project, and it works as a tutorial others can follow with a printed pattern.



The construction is classic vegetable-tanned work at 2.7 mm thickness. The pattern is traced with an awl, then the silhouette and the eye slits are cut out and the perimeter gets beveled. After dampening the leather with a sponge, holes are punched for straps and stitching, and geometric stamps with a mallet add texture across the face. The piece is dyed green, the strap tabs are folded and fastened with hammered brass rivets, and a pre-formed nose piece is stitched into the bridge opening. A kangaroo lace threads through the side loops with sliding knots, giving an adjustable headband.



The hardening stage is what stands out for me. Beeswax is melted in a saucepan, ladled over the piece, blotted with paper towels, then driven in with a hair dryer before the warm leather is molded onto a styrofoam head form. The wax version comes out at 31 g against 27 g for the water-shaped one. The printed pattern at full size suits a 59 cm head, so anyone else needs to rescale it.



One trade-off is worth knowing: the rigid frames can shift out of alignment if the wearer pulls exaggerated expressions. The brown water-shaped prototype added vertical slits for better downward sightlines, which seems a sensible refinement.



Project by Nils Beardfoot. Watch it on their YouTube channel:

formatting link


This is exactly the kind of small project I have been wanting to attempt, and the wax step is the part I understand least. How does the maker actually get the beeswax into the leather? Is it a quick dip or a slow soak, and how much of it ends up on the piece?

From what the tutorial shows, the beeswax is melted in a saucepan and ladled over the leather rather than dipped. The excess is then blotted off with paper towels and a hair dryer drives the remaining wax in while the leather is still warm. Right after that, the piece is molded onto a styrofoam head form to set the shape. The finished wax-hardened goggles weigh 31 g, compared to 27 g for the water-shaped version, so the wax does add a little weight.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required