Retro gaming leather bifolds with laser-cut color inlays

Nov 18, 2026 Last reply: 3 hours ago 3 Replies
Jump to replies (3)

The toughest part of this build has to be the artwork itself. A Switch console and an NES controller rendered in leather demand a lot of exact cuts, and Ethan Carter Designs tackled that with a new enclosed 22-watt laser running line mode at 250 mm/min and 82.5% power. The reference images were traced into vector paths in Affinity Designer, then brought into LightBurn to set up the cutting, with the machine's overhead camera used to line everything up on the leather. That workflow sounds like the right way to keep dozens of tiny shapes consistent.



The way the wallets come together is what stands out for me. Sheet leather in black, brown, grey, red and teal gets masked with low-tack paper and blue tape, then cut on the honeycomb bed. The colored pieces are then fitted together like puzzle inlays on a base backing layer and bonded with a water-based contact adhesive spread on with a foam brush. Building the color up from separate leather pieces rather than one surface treatment seems a smart call, since the picture and the material are the same thing.



The finishing side is thorough too. Notched card pockets are scuffed, glued to the reverse and trimmed, the inner console details are saddle-stitched by hand, and the perimeter is punched and stitched all the way around. Edges are sanded flush, burnishing gum is worked in by finger, then buffed with a wooden slicker.



One wrinkle worth noting: some of the smaller cut pieces dropped through the grate and had to be retrieved from the machine's pull-out collection tray. I'd want to know how much time that cost before committing to a design this detailed.



Project by Ethan Carter Designs. Watch it on their YouTube channel:

formatting link


The puzzle inlay construction is the choice I keep coming back to. Fitting individual colored cutouts onto a backing layer trades a lot of extra cutting and gluing for a design that is genuinely leather all the way through. In my view that trade is worth it, and the five-color palette gives the console and controller artwork real depth.

Does the blue tape and low-tack paper leave any adhesive residue on the surface once it is peeled off the leather? With masking going on before cutting and all those small inlay pieces coming out of the same sheets, I am curious whether the faces needed any cleanup before the adhesive went down.

For the masking step, it might be worth spraying Windex on the tape and letting it sit before peeling, since that loosens the adhesive and should make removal from the leather easier. Given how small some of the laser-cut pieces are, anything that reduces fiddly cleanup around those inlays would speed the whole process up.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required