Vicmarc VL300

16 discussions on InspirePoint about the Vicmarc VL300: what owners asked, what went wrong, and what fixed it.

What owners report

Super Nova vs. Oneway Chucks

Hi, my name is John and I am new to this group. I am also new to woodturning. I would like some advice as to which chuck to buy for my Jet 14-42 lathe. Can someone give me some good advice? TIA. John

What is best lathe manufacturer?

I know this looks like a troll. But, I have come to a point where I may beable to go higher that the Nova 3000 I was considering and wanted to getyour esteemed opinions on the best manufacturer.could you please help rate the manufacturers...

Vicmarc VL-300 review

After being able to use my Vic for a couple of months now, I have posted a detailed (plenty of pics) review of it. The article can be read at:

WTB - Nova 3000 lathe

After much deliberation (and the advice of everybody I could ask), I havedecided that the Nova 3000 lathe is the one for me. I like the heavier dutythan the Jet JWL-1442 and the better price than the JWL-1642.Further, I appreciate the...

question and drive by gloat

I have a question about my new Vicmarc VL300 (that I bought for $1500 dollars from a world famous turner!) It's a 220v 2hp motor and I don't have 22o wired in my shop. I bought a 30amp 220v circuit breaker, wired both the black and white...

Delta X 46-765X Lathe

I was wondering whether anyone has had the opportunity to check outthe new Delta X lathe. From the sounds of the specs, it appears tohave a lot going for it concidering the price is around $2000. I'm inthe market for a larger lathe but...

All discussions