HELP!!! CAN'T RAISE BOBBIN THREAD

I have tried everything short of standing on my head and still can't get the bobbin thread to raise. I have changed my needle, adjusted the top thread tension both ways, re-threaded the machine many times, changed bobbins and rethreaded it twice, and read the book cover to cover. any suggestions would be very helpful. I have a brand new (only used once before now) Singer Inspiration 4220/4228. please help asap!!!!

-------------------------------------

##-----------------------------------------------## Delivered via

formatting link
Community of the NetWeb and RSS access to your favorite newsgroup - rec.crafts.textiles.sewing - 3303 messages and counting!##-----------------------------------------------##

Reply to
kater2345
Loading thread data ...

-------------------------------------

well I finally got the bobbin thread to raise by pressing the foot peddle for about a second and that finally produced the loop and allowed me to finish what I was working on. but now I have another question: do you think something is wrong with the timing?? I received this as a Christmas gift, of course still in the box and have only used it once before last night. any suggestion??

##-----------------------------------------------## Delivered via

formatting link
Community of the NetWeb and RSS access to your favorite newsgroup - rec.crafts.textiles.sewing - 3303 messages and counting!##-----------------------------------------------##

Reply to
kater2345

Short of there being a mechanical problem with your machine, I can only suggest that you make sure the two tails of thread are about four inches long and *hang onto them* while you lower and raise the presser foot. Perhaps they're getting pulled down into the bobbin case?

If that doesn't help, then post again and describe exactly what happens when you try to raise the bobbin thread. Someone here will be able to help. ;-D

Reply to
Trish Brown

You shouldn't need to press on the foot pedal. Raising the bobbin thread should happen as you gently turn the flywheel a turn or two (needle-down, needle-up) while holding the end of the needle thread. (Sorry: you don't hold onto *two* threads as I said earlier, you hold onto the *one* that comes from the needle, drawing it between the 'toes' of the presser foot and hanging onto its end as the needle goes down and then up).

NB. The flywheel is the big one at the upper right hand end of the machine

I'd hope there's nothing wrong with the timing of your machine. You'd have to be pretty unlucky for that to have happened. Maybe you've made a small error in threading? Did you wind your bobbin as per instructions? Have you got just a short length of bobbin thread sticking out? (2"-4")

Most new machines come with complimentary lessons. Why don't you contact your local Singer centre and see what they're prepared to offer you? If nothing else, surely a kindly shop assistant will show you how to thread the machine correctly and get started. Most sewing folk are really helpful in that way. I'm not familiar with your machine model (my own Singer is hitting forty years old - euwww!), but most problems are common to all machines. Keep trying! The mistakes we make at the beginning are the best lessons we learn! :-D

Reply to
Trish Brown

Would not be timing if it sewed once you got it up. Sounds like poor technique to me.

Reply to
Ron Anderson

Perhaps you were pulling the needle thread at the wrong angle? It's awkward, in a side-threading machine, to pull the thread to the right with your left hand while turning the handwheel with your right.

(Perhaps that's why all the new machines have front-threading needles? More likely it's because tandem twin needles can't make pintucks. In a front-threader, twin needles work side by side.)

Joy Beeson

Reply to
Joy Beeson

InspirePoint website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.