Hi Ron - I thank you and all the others who replied to my question. Not quite sure exactly what I'm going to do, yet, but it appears I do have some options. Thanks again all, Deb
R>
formatting link
> I hope it turns out for the best,>
Cheap mini-lathe for modelling
Nov 09, 2003
23 Replies
found my cheat sheet
HTH Dale
STANDARD TAPERS
Taper Large Taper/ Taper/ Angle Small Length Name End Foot Inch From End Center
----------------------------------------------------------------------- #0 Morse 0.3561 .6246 .0521 1.4908 0.2520 2.00 #1 Morse 0.4750 .5986 .0499 1.4287 0.3690 2.13
I'll measure it Friday and report back. Thanks for the info.
Peter Teubel Milford, MA
formatting link
Where in Israel did you buy it and how much does it cost here? Thanks Joe
formatting link
> I hope it turns out for the best,>
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required