need candle stick holder help

Hi all, I've been comissioned to do a bunch of candle stick holders and was wondering if someone can steer me in the right direction or web site. I have to make about a dozen different holders for a craft fair and would like to view different styles and shapes to get some ideas. Thanks in advance Dan

Reply to
Dan Parrell
Loading thread data ...

Try eccentric turning:

formatting link
down to the very bottom. You can turn these between centers also, just offset-turn each section about 1/4" from center on three different axii about 120 degrees apart. While at actual center, turn a mounting spigot for your chuck at the base for boring out the candle cup hole after everything else, then reverse mount the cup on a jam spigot in the headstock with the tailstock into the base's center to finish off the bottom. Feel free to vary this technique, it's just a suggestion.

Ken Grunke

Reply to
Ken G.

Reply to
James R. Shields

InspirePoint website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.