BlankI have a craftsman split phase motor to run my lathe. It worked = well, then I took it off the lathe to build a new table. I must have = pulled off some wires, and I can't figure out how to wire it. I had a 6 = pole 3 throw switch to reverse the motor as well as an on-off switch. = The motor used to start spontaneously when the switch was at either = extreme position. Now when I lug it in, with any arrangement of wires, = it doesn't start spontaneously, but if I give it a push it will go...in = either direction of rotation, depending on which way I push it from = stand still. It is a 1/3 horse craftsman # 19669. here are three wires = from the motor; blue, yellow and red. There are three terminals in the = motor box and I have a black wire attached to the top terminal. I think = the blue and yellow wires are the power circuit.
Any help is greatly appreciated. Thanks.