1. Home
  2. Woodturning Crafts
  3. thanks and another question

thanks and another question

Thanks for the suggestions on mounting drill press to the floor or to a piece of plywood. I will mount it to something, just not sure about the 4x4 size.

I need to ask a question about mandrels. I've been reading the pen books and I understand the idea of mandrel shafts. But I'm looking in the Berea Hardwoods catalog (page 3), and they offer a "drill driver #1 MT" and "drill driver #2MT". I'm not exactly sure what this term means. Can anyone point me towards a resource that discusses "driver drivers"?

Thanks. Steve

Reply to
Steve
Loading thread data ...

Steve wrote:>Thanks for the suggestions on mounting drill press to the floor or to

#'s 1 and 2 Morse Tapers. Check the specs on your lathe(or drill press), to find out which one it takes. Sorry, "driver-drivers" are a new one on me. Tom

Work at your leisure!

Reply to
Tom

InspirePoint website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.