Woodturning Crafts

  1. Home
  2. Woodturning Crafts
7010 Threads Posts
to

Worth reading in Woodturning Crafts

Veneering

I am getting ready to try my hand at veneering. I noticed that most of the rough cut veneer has small holes in it from...
0 comments posted 19yrs
posted by 1ajdeluca
0 comments posted 19yrs posted by 1ajdeluca

On "the addiction"

Hello all- So as not to impinge on Arch's "musing" niche, I figured I'd use Aristotile's form for titling a diatribe......
8 comments posted 19yrs
posted by prometheus
8 comments posted 19yrs posted by prometheus

creative woodturner software

hasd anyone used this software- comments please ?anyone have software they want to sell?
1 comments posted 19yrs
posted by cheltondale47
1 comments posted 19yrs posted by cheltondale47

Vicmarc, Oneway, Stubby, or VB

All of these lathes cost within the $4K to $6K range, and all are fine machines for even the pro turner. But I'm curiou...
5 comments posted 19yrs
posted by maxprop
5 comments posted 19yrs posted by maxprop

Lighting tip

One of the fellows at the club came up with an idea. Get a halogen 50w light bar (3 lights & his had flex fixtures) and...
8 comments posted 19yrs
posted by tomnie
8 comments posted 19yrs posted by tomnie

Feed-n-wax food safe???

I saw this product at Home Depot. Since it is beeswax, carnuba wax and orange oil I wondered if it would be food safe....
2 comments posted 19yrs
posted by massmans
2 comments posted 19yrs posted by massmans

Vacuum chucking on a DVR

I have an adapter for vacuum chucking on my DVR. The thing is basically a sealed bearing and a shaft which fit into the...
8 comments posted 19yrs
posted by mike
8 comments posted 19yrs posted by mike

Which Midi lathe?

I am new to wood turning. A few summers ago I bought an almost unused Craftsman wood lathe with duplicating attachment....
33 comments posted 19yrs
posted by turner
33 comments posted 19yrs posted by turner

Hey Fred Holder - congrats!

Fred: Just saw your article in the international version of Woodturning. Nicely done! I didn't know we had an internati...
1 comments posted 19yrs
posted by nailshooter41
1 comments posted 19yrs posted by nailshooter41

Kenny Port Greetings from New zealand

Hi Folks, This is my first post since selling Woodcut tools in 2005 and its good to get back on the lathe and into the...
2 comments posted 19yrs
posted by kenport
2 comments posted 19yrs posted by kenport

Lathe applied finish

I normally spray a finish but on repair work I need something that will dry much quicker. I was wondering what most use...
18 comments posted 19yrs
posted by dicky
18 comments posted 19yrs posted by dicky

Burning Question

Hi all If you use a thin wire to burn the outside of a bowl or spindle, wha would i use to burn the inside of a curve su...
10 comments posted 19yrs
posted by Woodborg.2m0nil
10 comments posted 19yrs posted by Woodborg.2m0nil

Grizzly 642 lathe

Thinking of getting back into turning, Been MANY years....Anyway, this = lathe is a 16" swing, 2hp, but not reversable,...
2 comments posted 19yrs
posted by ricksub
2 comments posted 19yrs posted by ricksub