Fifty Dollar 1954 Radial Arm Saw Brought Back to Life

Nov 16, 2026 Last reply: 1 hour ago 4 Replies
Jump to replies (4)

Most vintage radial arm saws either sit rusting in a corner or get parted out, so it is refreshing to see one headed the other way. Catspaw Customs picked up an AMF DeWalt 9 inch MBF for fifty dollars and is restoring it with the aim of putting it to regular use in the shop, not parking it on display. The machine dates from around 1954, and the purchase even included the original MB and GS manual along with a repair parts book.



The teardown was thorough, covering the table mounting brackets, arm locking assembly, column pillar, elevating screw, trunnion, carriage and motor mount, with hand wrenches, Allen keys, a cordless drill, hammers and a rotary tool doing the work. Before stripping the old green textured paint, a negative lead swab test was run on the original finish. Then came chemical stripper with scrapers, wire brushes and scouring pads, followed by chemical rust remover on the machined steel surfaces.



The finishing choices stand out to me. Blue painter's tape masked off areas that stayed bare, the cast iron parts got spray primer coats, and the cast aluminum carriage arm, motor bracket and blade guard were smoothed with files, a benchtop wire and buffing wheel, and a random orbital sander. The riveted badges and measurement scales came off by grinding and drilling out the steel rivets, which takes patience.



Two fixes show real problem solving. A bolt on the elevating crank mechanism had a rounded-out head, and an auxiliary bolt was welded on so a wrench could turn it out. A damaged section of the blade guard rim was filled with JB Weld epoxy and filed flush. The one thing I am still curious about is the frayed original power cord, since replacement was needed and that is the piece I would most like to see resolved.



Project by Catspaw Customs. Watch it on their YouTube channel:

formatting link


Welding an auxiliary bolt onto that rounded-out elevating crank bolt is the kind of fix I respect. Rather than drilling the head out or cutting a new slot, a sacrificial bolt gives the wrench a fresh hex to grab. The trade-off is heat near the mechanism, but on a stripped head like that it beats shearing the fastener and chasing a replacement for a seventy year old machine.

How were the riveted badges and measurement scales removed without chewing up the castings underneath? I have always been nervous about grinding rivets on a machine where the surrounding surface is going to be refinished, since one slip with a wheel would leave a mark that primer alone will not hide.

From what the maker showed, the badges and scales came off by grinding and then drilling out the steel rivets, so the rivet heads were taken down first and the shanks drilled through. Given that the castings were getting stripped and refinished afterward, minor tooling marks around the rivet holes would have been cleaned up during the surface prep stage.

Since the aluminum carriage arm, motor bracket and blade guard were filed, buffed and sanded to a smooth finish, I would suggest a protective clear coating over those bare surfaces. Freshly polished aluminum in a shop environment dulls quickly with dust and humidity, and a clear layer would preserve the bright look while still letting the contrast with the primed cast iron read the way it does now.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required