Jump Ring Help!

Mar 06, 2004 10 Replies

Ok, to fill orders I need to obtain somewhere in the region of 800 Sterling Silver jump rings very quickly. My supplier has gone out of stock and I am not prepared to pay £50 for something when I would usually get it for £20. Can anyone either:



a) Recommend somewhere in the UK to buy them from.



b) Recommend somewhere abroad who have reasonable prices, postage and who are quick to post



c) Recommend a good way of cutting them. BF has a Draper multi tool (like a Dremel but better apparently) but the blades weren't thin enough to make a good clean cut without losing too much metal, I haven't seen any thinner blades made for multi tool either. Do jump rings come out just as well if you cut them with good wire cutters? I've contemplated trying it, but would like to know if anyone else has done it before me, if it doesn't work then it saves me wasting wire.



Charlie.


Here is a tutorial on making your own jump rings which is very easy to do. All you need is round sterling silver wire. Roxan

Thanks for the link... that was how I made some before but the blade of the multi tool just is too thick and I can't find any thin ones which is why I wondered if it would work with wire cutters.

Here is a comparison web page so you can see how to make them:

formatting link
Hope this helps you. Harry

Harry My Ebay Auctions are at

formatting link

Have you checked with Lynda?

formatting link

Don't know if she ships overseas but I've bought her jump rings and I know they're well made.

What if you make the rings slightly bigger than you need to compensate for the loss when you cut them?

I believe wire cutters will pinch them into a V at the end instead of giving you two straight cuts to match up.

Tina

When I made my jump rings I used to wind the silver wire around a metal mandrill with a v cut in the end. Then using a piercing saw with a very fine blade I would saw through the top of the coiled wire. Making sure I had something underneath to catch them as they dropped off. Shirley

In article , Christina Peterson writes

Harry My Ebay Auctions are at

formatting link

A gal I know gave me the following tip on making jump rings:

She said to use flush cutters to cut the rings off the coil, and use two snips for each ring.

For the first snip, put the flat side toward the ring you're cutting off. This makes the "v" cut in the end on the coil. The second snip comes when you flip the flush cutter around so you'll make a flat cut on the coil (you get a double-pointy bit that you throw away), and then to complete that (second) ring, flip the flush cutters over again so the flat side is to the ring.

I know this probably sounds confusing -- you just keep turning the flush cutters over and back, basically, to make two flat ends to each ring, rather than one flat and one pointy.

I hope this helps! Karen :)

Christ> I believe wire cutters will pinch them into a V at the end instead of giving

Thanks for the link, unfortunately I think they work out incredibly expensive compared to what I usually buy!

Charlie.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required