I have been playing with Husqvarna Customizing recently and I am wondering how to change the size of a design so that it is less than
-20 (even smaller). It says that that's the maximum limit for one-time scaling allowed per file.
But if I do need it to be even smaller?
Another question: when I combine several designs, and then change their colours respectively, I expect to see maximum three unique colours (for example). However, because there were several patterns added, the schema shows one and the same colour several times (even though I run the program to analyze that).
How do I avoid repetitions of colour? I would like the embroidering to be continuous inside the limits of one colour, but instead I have to do it several times for, say, red.
Thank you very much!