just picked up an old lathe model no. 46-111 i think ser # GD 8661. the threaded end of the head stock spindle is split. i can use a chuck on it just fine however the morse taper being split scares me a little. anyone know where to get a new spindle for this? OWWM has changed the site and i cant find anything there now. may as well get new bearings while i am at it huh?
thanks
skeez
I think you should be able to get bearings at a local bearing distributor. Take the old ones with you and they can match them.
With the split head stock spindle, why not try threading two nuts on it with a lock washer between them. The nuts should stay in place because of the lock washer and they should keep the shaft from splitting any further. Certainly is a lot cheaper and easier than replacing the spindle.
Harry
i had not thought of that but i should work. replacing doesnt look to be difficult but finding a new spindle might be rough! :-] I would still like to replace it though IF I can find one.
skeez
Try Ace Tool Repair. For the 46-111 lathe see:
You know, every once and a while I think no one is reading this group anymore. Then a gem like that one comes along.
Way to go Jack!
Robert
Have something to add? Share your thoughts — no account required.
Ask the community — no account required