1. Home
  2. Woodturning Crafts
  3. Making handle for shell auger

Making handle for shell auger

I've just bought an unhandled shell auger, and want to make a handle for it. That's not a problem, but I'm a little curious about how to actually fit the auger into the handle once I've made it. On the non business end, it's got what I can only describe as a blunt spear head, presumably this stops the whole thing rotating in the handle.

So, do I just drill a hole the same diameter as the shaft of the auger and somehow force the "spearhead" into this hole, or is there something else I should be doing. I guess I'll need some kind of ferrule too.

TIA,

Reply to
Alun Saunders
Loading thread data ...

If the tang of the shell auger is tapered I would drill the hole about 2 sizes smaller than the largest section of the tapered portion of the tang. Make sure the ferrule is in place before trying to insert the tang into the handle if it is not in place when you put the auger tang into the handle it may split the wood.

I could be wrong about this when it comes to a shell auger but when I have made file handles that is the way that I make them and it has worked well for me.

Reply to
Steven Raphael

Alun, normally the auger would go into a carpenter's 2 jaw brace. Sometimes a wood handle was fitted so as to form a T. To do this all you need is a suitably sized piece of round stock which you can chop a square tapered mortise into. Sometimes to add strength and prevent the auger pulling out of the handle, I have seen the square "blunt spear head" drilled and tapped in the end to take a bolt with a backing washer.

Reply to
Peter Hyde

InspirePoint website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.