i have a craftman dunlap lathe model #101.06242 and i need to get a spur center and live center, am i correct that this lathe has a #1 morse taper????
-- Knowledge speaks, wisdom listen..... Jimi Hendrix
i have a craftman dunlap lathe model #101.06242 and i need to get a spur center and live center, am i correct that this lathe has a #1 morse taper????
-- Knowledge speaks, wisdom listen..... Jimi Hendrix
Diameter of hole opening for a #1 morse taper should be a couple hairs over 7/16", while a #2 morse should be just over 11/16".
InspirePoint website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.