Awhile back I downloaded or saw in a magazine plans for a platform that bolted on the end of a 3520. You could slide the tailstock onto it and then tilt it out of the way. I'm ready to build it and lost the plans. I've looked and searched every site I can think of to no avail. I think I can re-invent it but I would much rather go with a proven design. Can any of you point me to it?
Earl
Earl, I believe this was printed as a tip in the tips section of the Winter 2005 American Woodturner magazine.
Rick
Hi Earl Here's a link to it
That's the one I wanted! Thanks. I'll go to work on it tomorrow. Here I thought I could get all the dimensions ready to go...oh well... LOL Thanks for the link. Earl
InspirePoint website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.