MDF is OK, but the dust and mess, and it is abrasive, so hard on tools.
In addition, the surface is harder than the centre, so if you are laminating layers, you will end up with hard and soft sections, like grain lines in soft timbers, which can make finishing more difficult than it need be.
That said, the stuff can be turned and easily as there is no grain.
We had a competition down here a few years back where one category as for "engineered wood". Follow this link to have a look at what you can do with it.
formatting link
go to Terrys gallery, and look at piece Number 8
I am making a prototype part for work that is basically a 18" bowl with a
> raised center. I was wondering if MDF would be a good candidate for this
> project. Any thoughts would be appreciated.
>
>
> ---
> Outgoing mail is certified Virus Free.
> Checked by AVG anti-virus system
formatting link
Version: 6.0.726 / Virus Database: 481 - Release Date: 7/22/2004>>