Sanding tool.

"Andrew Morrison" skrev i melding news:417c9e29$0$10003$ snipped-for-privacy@news-text.dial.pipex.com...

I made mine without an article:

2 sealed bearings, inner hole 6 mm, which is same as diameter of Sorby spindle-shaft, outer diameter not important, but good if it is same as one of your forstner-bits. Cost: $15

Some epoxi glue.

In my case, the spindle was a little too thick to enter the hole in the bearings, so I had to sand to get close. I do not know if this is important, but I cooled the spindle with ice from the freezer to shrink it into the bearings. It still took some adjusting (read: sanding).

Drill hole in the wood for the bearings, shape handle.

When both bearings are in place, fasten in handle with epoxi, each bearing flush with each side of the handle.

My "new" Sorby sanding tool has so far lasted med for over one year. but now the velcro is a bit worn, and I am planning to change the spindle.

Good luck.

Afterthought: At the prices Sorby charge for their sander, it is not very handsome on their part, that the sealed bearings are not already there:-|

Bjarte

There is an article on how to do this at

hope this helps

Bill