I have a Poulan, although the sticker says Patriot, that decided to stop oiling the bar. It used to take 1 tank of bar oil per tank of gas but now it just desn't use any bar oil at all. I looked to see if there was anything I can unclog or whatever but no such luck. This saw uses a little oil pump, it's not a gravity fed oiler, and according to a repair guy this is real common for them Poulans. All in all there's probably less than 24 hours of operation on this thing. A friend replaced the oil with gas to see if it would flush itself clean that didn't work either. Any other tricks or perhaps suggestions for a low tech way of making it a gravity fed set up? Thanks, Bart.
-
**botox treatments: taxidermy on the living**
Email replies via:
formatting link
awesome banjo bridges, tabs, stained glass: ===
formatting link
===