Woodturning Crafts

  1. Home
  2. Woodturning Crafts
7010 Threads Posts
to

Worth reading in Woodturning Crafts

nearly free - CH air compressor - U fix it

I have a campbell hausfield air compressor, model wl600602AJ with a bad piston ring - motor runs, the tank is good, the...
0 comments posted 19yrs
posted by nobody
0 comments posted 19yrs posted by nobody

question on Black walnut

Hi I've woodworker for over 30 years and full time for the last 3. I've have bought my share of commercial walnut over...
7 comments posted 19yrs
posted by pbesharah
7 comments posted 19yrs posted by pbesharah

Christmas Presents Idea in a.b.p.w.

Picked up a bunch of 3/8" diameter by 3 1/2" long glass test tube type inserts at the last WWing show and finally got a...
3 comments posted 19yrs
posted by charlieb
3 comments posted 19yrs posted by charlieb

pen turning observation

I had a pen which didn't seem to show any blemishes until after I had waxed it with pure carnauba wax. Then a divot sho...
28 comments posted 19yrs
posted by reply
28 comments posted 19yrs posted by reply

vacuum pump anyone

several folks from the NG have asked me for a 110V vacuum pump - I was just able to pick up one pump that is in a nice...
1 comments posted 19yrs
posted by nobody
1 comments posted 19yrs posted by nobody

Lathe for sale

I am selling my Vicmark mini lathe that has never been used. I bought it 2 or 3 years ago. It is similar to the Jet and...
1 comments posted 19yrs
posted by kayakaz
1 comments posted 19yrs posted by kayakaz

My new lathe toys...

Hello all, Well, I finally got around to tooling up to do some metal spinning- after a long delay and some hemming and...
12 comments posted 19yrs
posted by prometheus
12 comments posted 19yrs posted by prometheus

Competition Themes Edited

Thanks to all that responded to my earlier post which asked for ideas for competition themes. I have combined all the r...
0 comments posted 19yrs
posted by BillR
0 comments posted 19yrs posted by BillR

Norfolk pine

Any hints on how to deal with the tearout? Junior
8 comments posted 19yrs
posted by gibbsjr
8 comments posted 19yrs posted by gibbsjr

Adding weight to a Jet 1442

I have a Jet 1442 with the cast Jet legs. I would like to add some storage below the bed and as long as I am at it, I a...
8 comments posted 19yrs
posted by sawdust-nospam
8 comments posted 19yrs posted by sawdust-nospam

Ouch!

Hello, Here's another safety reminder. Yesterday, I was sanding the inside of a deep (5 in.) natural edge bowl. The rim...
7 comments posted 19yrs
posted by cblood59
7 comments posted 19yrs posted by cblood59

2436 OneWay lathe FS in Texas

Uel Clanton has a 2436 with 17" bed extension for sale. It also has the heavy tailstock legs (same as the headstock leg...
0 comments posted 19yrs
posted by JJOHNSON17nospam
0 comments posted 19yrs posted by JJOHNSON17nospam

Robust Tools Lathes

There are some nice lathes at www.turnrobust.com that are on the level of Oneway lathes. They offer 18x28 and 25x28 mod...
21 comments posted 19yrs
posted by woodstudio
21 comments posted 19yrs posted by woodstudio