Scrap wood jewelry box with flocked tray and splined corners

Nov 18, 2026 Last reply: 1 hour ago 4 Replies
Jump to replies (4)

When everything comes together, this is a small hinged keepsake box meant to hold jewelry, with a nested insert tray lined in black flocking. Lift the lid, which is held by small antiqued bronze hinges and a matching latch hasp, and the tray sits inside waiting for rings and earrings. It is the kind of piece that turns leftover stock into something with a real job.



The build leans hard on scraps, and that is where the charm sits. The maker milled pieces of jatoba and purpleheart, then cut the box sides to length with mitered corners on the table saw. A spalted pecan slab cut-off was trimmed down for the lid, and walnut plywood was sized for the bottom. After the main box was split into base and lid, it went on a spline jig and got reinforced with purpleheart corner splines, later trimmed flush with an oscillating multi-tool. The tray itself came from glued strips of purpleheart and walnut plywood.



Several touches stand out to me. Dados and shop-made sled jigs kept the miters honest, an inverted trim router added decorative chamfers to the lid edges, and Rubio Monocoat went on every component. A 16-32 drum sander brought the boards to uniform thickness after resawing, which the maker did on the table saw because the bandsaw blade was dull. That kind of improvisation says a lot.



One thread left hanging: a propane torch was used to attempt heat-treating the tray exterior, and it reads as an attempt rather than a settled result. How that surface ultimately finished out seems like the open question here. There was also a crack in the tray along the way, handled with CA glue and accelerator, which feels like a fair save on stock this small.



Project by Moonpie Creations. Watch it on their YouTube channel:

formatting link


I would love to know how the tray strips were held during glue up. Was the blue painter's tape really doing all the clamping work on those little purpleheart and walnut plywood pieces, or did the maker have some other trick for keeping the strips aligned while the glue grabbed?

Reinforcing the miters with purpleheart corner splines strikes me as the cleverest call in the whole build. The contrast against the jatoba gives the corners a deliberate look, and splines are a much stronger answer for mitered corners than glue alone. The trade-off is the extra slotting and trimming work, but on a gift piece that effort seems worth every pass on the spline jig.

A variation worth considering: flock the main compartment floor to match the tray. Right now the black fibers are only inside the tray, so a matching flocked base would carry that soft finish through the whole interior and give the lower level the same protection for pieces stored under the tray. It would also echo the black flocking against the bronze hardware nicely.

The maker has said the parts were assembled using wood glue and blue painter's tape, so tape was clearly part of the clamping approach. Beyond that, nothing more detailed about how the tray strips specifically were held under pressure has been mentioned, so I think the honest answer is that we only know the glue and tape combination.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required