Walnut slab bookcase with butterfly keys and dado joinery

Nov 20, 2026 Last reply: 2 hours ago 2 Replies
Jump to replies (2)

Every shop eventually ends up with a leftover slab too pretty to cut up and too awkward to use. That is the situation this project tackles: a big, irregular walnut live-edge piece becomes the rear of a tall shelving unit, and instead of hiding the wood, the whole design puts it front and center. Because it started without a client brief, the maker had total freedom, and it shows in how confidently the slab drives every other decision.



The construction is straightforward but well thought out. The design came together through sketches and digital mockups, and shelf sizing followed the stock on hand rather than any strict proportional formula. The shelf boards are edge-glued panels, joined to the rear slab and to a pair of front uprights with dados. Those uprights came from oversized stock ripped down the middle into two matching legs, which is a neat way to guarantee symmetry.



The detail that stands out to me is the repair work. Cracks in the slab were stabilized with hardwood butterfly keys, with the pockets cut on a Shaper Origin before the keys were glued in, trimmed flush, and sanded. There was also a setback worth noting: an up-cut spiral bit slipped from the collet and wrecked a test dado on the large CNC table. The pivot afterward was sensible in my view, moving the leg dados to a cabinet saw and hand router while the slab dados went to a down-cut spiral bit on the CNC.



Finished, the piece stands 80 inches tall with shelves roughly 45 inches wide. One open question: the documented work ends early in fabrication, so the final assembly and completed bookcase are not shown anywhere.



Project by Foureyes Furniture. Watch it on their YouTube channel:

formatting link


That slab rear is a lovely anchor for the whole unit. I am curious about the shelf sizing, though. Did the maker settle those dimensions by working to a set proportion or a formula, or was it driven by something else entirely? It always interests me how much of a design comes down to what material is actually sitting in the shop versus what looks right on paper.

The maker sized the shelves around the stock available rather than following rigid proportional rules such as the golden rectangle. Sketches and digital mockups were used to develop the design, so paper still played a part, but the final dimensions came from the material on hand. Given that the whole piece is built around a remnant slab, sizing to the stock seems like a fitting approach.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required