Where should I post a pic?

Question

Where should I post a picture for all you people to see?

I have a design that I created that is approx. 28 x 47" shutters/valance that I would like to have time input on.

Thanks, Steve

Count me as a lurker posting!!

Steve · Accepted Answer

Excuse me, Should read ... have some input on.Thanks,  Steve

neoglassic · Answer

Put it here:  After you have it loaded, comeback and post the Steve wrote:

Steve · Answer

Here is the URL:   top is approx. 12" tall. My biggest question is- Do I have to worry about my hinge points?I was planning on using just standard pivot points for  will be a little bit of zinc caming on both panels for some extra reinforcement.Any input would be great.Thanks,  Steve

neoglassic · Answer

Is this one single panel or what? If so, then the top section is definately a huge hinge problem unless you're going to have zinc go all the way around it...if it's one single panel. Why not build it so that you can put it in a wood frame and then you'd be able to use hinges.

Andy

Steve wrote:

glassman · Answer

1/2"-3/4" zinc all around, and solder the hinges to the flat zinc, or  use a wood frame for the best support.

murano · Answer

Steve, put your photos in  or in . Regards,Steve wrote:

Steve · Answer

The top 'Music Staff' panel will be stationary, with the 2 bottom panels acting as shutters.

I was hoping to try and get by without any wood.

I've got some zinc caming that I would try to place diagonally across each panel.

Thanks, Steve

neoglassic · Answer

Oh ok. I guess my only concerns would be when you open them, will theyhave a tendancy to want to flex? There is small pretinned steel rebaryou could use or do the zinc thing. Andy

Where should I post a pic?

Join the Discussion

Didn't find your answer?