As I was talking about earlier *using Pearl Ex with clear embossing powder* I went out and bought some clear embossing powder to try it. I also wanted to buy some more eyelets or dotlets in a certain color to finish my ATC cards. I couldn't find the color at Michaels. I thought I probably got the dotlets in a swap and started thinking I may not find that color and I REALLY wanted it, because it look so good. Then suddenly I thought I wonder if I could use the Pearl Ex powder and clear embossing powder to emboss some dotlets I have that aren't the right color. In essence turning them into the right color.
I mixed the clear embossing powder and Pearl Ex in a 4 to 1 ratio in a small cap I had laying around. I used my tweezer bees to hold dotlet by the bottom. I used Versamark to adhere the first coating of Pearl Ex laced embossing powder. Then I heated it. While coating was still hot I dipped it back into the powder heating it again. I then dipped it while still hot in the Pearl Ex powder by itself. Again heating to seal it on the dotlet. I dipped it probably 4 times in Pearl Ex laced embossing powder and 2 time in the Pearl Ex powder itself. They looked beautiful! They matched my card perfectly as I had used the same powder in the making of them.
Next test when I pounded them on to the card I wanted to make sure the color didn't crack off. It didn't! I did after the first one fold a tissue up and cushioned the dotlets as I pounded them on. The first one looked like it may have been scratched on the plastic mat.
So, I can now make eyelets match what I'm working on fairly easily.
Lynne