anyone used one of these?

not quite "woodturning" but related ...

formatting link
or equivalent

comments?

Reply to
tom
Loading thread data ...

It's a "must have tool" if you have drill bits. Easy to use and the results are spectacular, especially if you are drilling steel.

LB

Reply to
LBledsoe

there are several models of the drill doctor - they work OK, but the older ones have a problem holding a consistent relief angle - sometimes you get negative relief and the drill doesn't do anything. But, it's a lot cheaper than the $6000 Darex

Reply to
Bill Noble

I worked as a machinist for about 8 years running a drilling department. We used everything from .015 up to 3". I watched the tool crib guy hand sharpen drills and thought it looked easy. Tried it myself a few times and found it was easy. If you have an eye for it, it becomes very easy after a few tries and only requires a bench grinder with a squared up wheel. If you have a bench grinder and wheel dresser try it out a bit before you buy a drill doctor. You may find you don't need it.

Reply to
sbnjhfty

I have a slightly larger model which has a gizmo for setting the drill correctly in the holder.. Looks like this one you do that on your own. Just works on standard twist drill bits and I think concrete bits.. Haven't sharpened any of the latter, but it's a fast, handy, no-brainer sharpener for twist drills.. Won't work on brad point drills, etc..

Reply to
Jim Hall

Yes, got one for Christmas 2 or 3 years ago. I had a cigar box full of dull bits and sharpened the whole lot. It worked well. Will not sharpen brad points, spade bits or Forstners, of course. I wish I had a forstner bit sharpener.

Reply to
Gerald Ross

Gerald

formatting link
CYA Steve

Reply to
Stephen Quinn

I've got all that stuff and have piddled at sharpening some, but I was thinking of semi-automatic mechanized sharpening.

Reply to
Gerald Ross

I agree with some of the posts.

I have a different model - 3/4" max size - and it turns a rounded tip - not two flats. I can cut cross points - that is great.

I saved a chipped 3/4" drill - high quality - and after grinding it I then hand ground the flutes for a undercut from the cutting edge.

I do a lot by hand, but preform some extensive jobs with mine.

Martin

tom wrote:

Reply to
Martin H. Eastburn

InspirePoint website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.