My new website.

Actually, I did click on that. Several times. It's working now, but it didn't work when I first tried.

Did you read this on that same page?

"Download and extract the zip-archive from below."

If so, could you pass me the link for "the zip-archive below"?

And kill the caps.

Bill

There is no link below just use the DOWNLOAD link follow it answer the question and save the download it is a ZIP file, also read the install directions. IF THAT IS NOT TOO HARD! then again just give up as it could be an ID ten T problem, you know the one problem that exists betwwen the seat and the manual interface.

Awesom Gerard! This is just the kind of web photo software I have been looking for.Thank you very much!

`Casper

Lay off the bud. The acronym you are trying to insult me with but can't seem to remember is PEBKAC. RTFM.

Google is your friend. Possibly your only one.

Bill

Yes, thank you, Gerard.

I got distracted and forgot to express my appreciation. I am going to give it a trial off-line and, if I can work it into a personal genealogy site I am starting to develop, I'll send the $30 even though it's not required for not-for-profit sites.

Bill

Thanks! I'm looking out for a flex shaft set-up at the moment, your suggestion on carving and a small sanding disc gives me some new ideas like putting a small powercarverblade (like the arbortech mini Industrial Woodcarver) on a angle-toolholder.

Gerard

You are on the wrong newsgroup for this behavior.