Nova 3000 question

Hi Greg, I don't own a nova 3k but have read a lot of posts here where the setscrew in the headstock pulley has worked loose or moved out of alignment. There were also people reporting vibration and found the knockout bar left inside the spindle by mistake.

Bob, Naugatuck Ct.

Hey Bob, I too read some of those post and checked both pulleys and while i have left the knock out bar in the shaft before this isnt the case this time. I have had problems with the motor on several occasions and i think perhaps that may have caused some problems...I will have to contact woodcraft and see if they have had any reports of this and what can be done to correct the problem.

Thanks,

Greg