Pull the two leads from the door switch and connect them, by passing the
> switch. If that doesn't work, is the emergency button on the control panel
> locked in the in position. If that's not it - what error message is being
> displayed on the inverter, i.e. E6.
> > Today I was finishing a small bowl on my lathe and when I attempted to
> > increase the speed nothing happened. I reset it to no avail. Anyone have
> > similar problem and know the fix?
> > Thanks
> >
> >
>
>
Hello Paul, Please call me at 1-800-565-7288 and I will do my best to get you fixed up. If the lathe is not changing speed the speed pot has probably gone bad. If so we can reprogram the drive to take the speeds from the keypay, this is a bit of a pain but keeps you going until we can get you a replacement part. If the lathe has gone to minimum speed and will not speed up one of the wires may have become disconnected at either the speedpot or drive. regards Kevin
thats what i call good service. well done kevin.
Have something to add? Share your thoughts — no account required.
Ask the community — no account required