Anyone knows the shimpo or brent wheelhead's pins thread size? is it
1/4-20?
Thx
Wheelhead pins
Mar 23, 2006
2 Replies
1/4-20?
1/4-20 cap screw.
a friend told me to replace my pins before re-drilling all my bats. the bats were holding loosely on the pin heads.
i was STUNNED how that simple change tightened up my bats!
the heads wore down A LOT & i hadn't noticed.
see ya
steve
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required