Small Sandblast Templates

Hi Steve,

I would think any tool & die shop with an EDM, or laser machine could do it,....at a substantial cost. I have made my own stencil out of silicon rubber sheet. I found the rubber at a local hardware.

These are pretty basic, but they work great. I just took a regular set of paper stencils and traced them down onto the rubber. I then cut the rubber out with an exacta knife. The rubber holds up fine to the sand blaster. I use a little spray adhesive to hold it down to the glass. Then clean it up with acetone.

Randy Hansen SC Glass Tech Scam Diego, Comi-fornia

Most tempering shops I've seen use rubber also, get more life out of them.

You could have a sign shop do your logo in resist. Numerous copies, just peel one off when you need it.

Many thanks to you all for the excellent advice - this group is such a valuable resource!

~steve